
Researchers in China have investigated how screen printing degrades copper-plated silicon heterojunction (HJT) solar cells and developed a method to reduce that effect, according to a study published in Solar Energy.
Lang Zhou, the corresponding author, told pv magazine that the screen-printing process for photoresist application differs from conventional silver paste printing. In silver paste printing, the screen openings account for only 2–5 % of the total area, and an emulsion layer covers the rest, preventing direct contact between mesh and wafer. Full-area photoresist coating typically uses a screen without emulsion coverage, so the mesh comes into direct and extensive contact with the wafer during each printing cycle.
The researchers said previous investigations had shown conversion efficiency declining from 26.2 % to 25.7 % over 15,000 consecutive printing cycles in commercial solar cell production, mainly through reductions in open-circuit voltage and fill factor. Minority carrier lifetime degradation rose from 0.61 % with a new screen to 11.0 % after 15,000 printing cycles.
Using three-dimensional confocal microscopy, the scientists identified progressive wear of the screen mesh knuckles as the main cause. As the knuckles wore down, their contact area with the wafer increased, placing greater mechanical stress on the passivation layers. Scanning electron microscopy revealed no visible surface scratches, but photoluminescence measurements confirmed increased recombination losses, suggesting damage to the amorphous silicon/crystalline silicon interface.
To address this, the researchers developed an emulsion buffer layer to prevent direct contact between mesh and wafer, and they evaluated six patterns with emulsion coverage ratios from 2.9 % to 16.6 %. The results showed a trade-off between mechanical protection and photoresist coating uniformity: higher emulsion coverage reduced damage but impaired ink distribution. A coverage ratio of 4.7 % provided the best balance, limiting minority carrier lifetime degradation to 0.41 % after 10,000 printing cycles while maintaining relatively good coating uniformity.
Zhou said the findings show that a relatively simple modification to screen design can substantially mitigate printing-induced degradation, offering a practical approach to improving manufacturing reliability of copper-plated HJT cells.
Context
The study appears amid interest in copper metallization as an alternative to silver contacts. In April 2026, researchers at China's Nankai University reported a silver-free HJT solar cell with 25.2 % efficiency using plasma-induced interface engineering and copper electroplating. Separately, scientists at Germany's Forschungszentrum Jülich reported 23.08 % efficiency in a fully copper-metallized HJT solar cell, with cells combining silver-copper paste on the front and silver contacts on the rear reaching 23.95 % efficiency. According to pv magazine, further improvements in processing and electrical performance remain necessary.
Key facts
- 26.2 % to 25.7 %: conversion efficiency decline over 15,000 consecutive printing cycles in commercial production
- 0.61 % to 11.0 %: minority carrier lifetime degradation from a new screen to 15,000 printing cycles
- 4.7 %: emulsion coverage ratio that gave the best balance among six patterns tested (2.9 % to 16.6 %)
- 0.41 %: minority carrier lifetime degradation after 10,000 printing cycles with the 4.7 % emulsion layer
Sources
- First attempt to address screen printing-induced degradation in copper-plated heterojunction solar cells — pv magazine
Other news outlets are named as sources but not linked.
Discussion
Technical questions and corrections are welcome. Comments are signed and checked before they appear.
No comments yet.
Sign in to add a typed review comment. Reviews are signed with your name.



