EPREVAEngineer Paper

Hooke's law (stress–strain)

In the elastic region, stress is proportional to strain.

σ=E ε\sigma = E \, \varepsilon
Playground · Hooke's law (stress–strain)
solve for
Strain
0.001 —
Plot strain against
0.0100.12,000 MPa (log)

Young's modulus E is the slope of the stress–strain curve in its linear, elastic part. Steel is about 200 GPa, aluminium about 69 GPa, so the same stress stretches aluminium roughly three times as much.

Strain is dimensionless: change in length divided by original length. Engineers often quote it in microstrain (µε = 10⁻⁶).

Variables & units

SymbolQuantityUnit hereSI dimension
σ\sigmaStressMPam⁻¹·kg·s⁻² [L^-1 M T^-2]
EEYoung's modulusGPam⁻¹·kg·s⁻² [L^-1 M T^-2]
ε\varepsilonStrain—dimensionless [1]

Rearranged

Solve forFormulaDimensions check
Stressσ=Eε\sigma = E\varepsilon✓ m⁻¹·kg·s⁻²
Young's modulusE=σεE = \frac{\sigma}{\varepsilon}✓ m⁻¹·kg·s⁻²
Strainε=σE\varepsilon = \frac{\sigma}{E}✓ dimensionless

The dimension of every rearrangement is computed from the dimensions of its variables by our expression engine — so a typo in a formula on this page would show up here in red.

Assumptions

  • Linear-elastic, isotropic material.
  • Stress below the proportional limit.
  • Uniaxial stress state.

Example

Steel (E = 200 GPa) at 200 MPa: ε = 200e6 / 200e9 = 0.001 — a 1 m bar stretches 1 mm.

Connected