EPREVAEngineer Paper
TRANSPORTNewsElectricalManufacturingTransport

ZF unveils 30,000 rpm integrated EV drive unit

The company claims nearly 25% less weight and volume and half the magnet mass than its 18,000 rpm Select unit, with production targeted by 2030.

a single compact integrated drive housing combining motor, power electronics and transmission; machined metal castings and cooling ribs; bolted flanges and a gearbox end cover; the small size implied by a clean studio setting
AI-generated image

ZF has shown a new electric drive unit, the High Revolution Drive, that spins up to 30,000 rpm and combines the motor, power electronics and transmission in the same housing. Unlike a Mercedes-Benz design that places the brakes inside the same housing, ZF's unit does not.

The company claims the new drive offers nearly 25% less weight and volume, half the magnet mass and a similar efficiency of almost 93% compared with one of ZF's comparable Select drive units, which spins up to 18,000 rpm. ZF says spinning the motor faster lets it deliver the same power from a smaller, lighter package; less mass improves EV range, and fewer magnets reduce costs and supply-chain dependence. Gears then reduce the speed and increase the turning force sent to the wheels, using a reduction ratio of about 18:1.

The version ZF showed produces up to 268 horsepower, with the gearing delivering peak torque of 2,581 pound-feet (3,500 Nm) to the wheels. That torque figure is measured after the gearing has multiplied the motor's output. The 'two-stage transmission' describes successive gear reductions rather than two separate driving ratios.

ZF says the production High Revolution Drive should deliver 200 to 268 hp and work with both 400- and 800-volt platforms. Reusing its modular Select architecture should simplify installation, shorten development and control costs, the company says. Talks with automakers are underway, with production targeted by 2030.

Open questions remain: ZF has not said which production EV would get the drive unit, and it is not known whether the engineering gains will remain unchanged from the announcement to a purchasable product. ZF has also introduced repair kits intended to let workshops fix individual drive unit components, such as gearbox bearings, instead of replacing entire assemblies. The company has not said whether the two developments are connected or whether the kits should be taken as a repairability promise for the new drive.

ZF is not alone in pursuing more output from a smaller package. One prototype of Yasa's ultra-compact axial-flux motor produced over 1,000 hp and weighed just 28 pounds, a short-term peak figure with continuous output estimated at 469–536 bhp. But Yasa's figure describes only the motor, while ZF's weight reduction refers to the whole integrated drive unit, which also houses gearing and power electronics.

Key facts

  • 30,000 rpm: maximum spin speed of the High Revolution Drive
  • Nearly 25% less weight and volume than a comparable ZF Select drive unit, per the company
  • Half the magnet mass and almost 93% efficiency, per the company
  • About 18:1 reduction ratio; peak torque of 2,581 pound-feet (3,500 Nm) to the wheels after gearing
  • 200 to 268 hp for the planned production version; production targeted by 2030

Sources

  1. This New EV Motor Spins To 30,000 RPM. It’s Designed For Normal Cars — InsideEVs

Other news outlets are named as sources but not linked.

Discussion

Technical questions and corrections are welcome. Comments are signed and checked before they appear.

No comments yet.

Sign in to add a typed review comment. Reviews are signed with your name.

More news