Introduction
Cell temperature drives battery ageing and safety, but few cells carry an internal sensor. Battery management systems (BMS) therefore estimate temperature with simple models. This note derives the most common one, the first-order lumped thermal model, and works through an example.
Model
Treat the cell as a single body at uniform temperature with heat capacity , exchanging heat with ambient air at through a thermal resistance . An energy balance gives
where is the heat generated inside the cell. Following the energy balance of Bernardi et al.[1] and neglecting the reversible (entropic) term, the heat generated is the irreversible loss
with the cell's internal resistance.
Steady state and time constant
Setting in (1):
For a step in at , the solution of (1) is
Worked example
| Parameter | Value |
|---|---|
| Current I | 10 A |
| Internal resistance R_0 | 20 mΩ |
| Heat Q = I²R_0 | 2.0 W |
| Thermal resistance R_T | 8 K/W |
| Heat capacity C_T | 70 J/K |
| Time constant τ | 560 s |
| Steady-state rise ΔT | 16 K |
Assumptions
- Uniform cell temperature (lumped capacitance), valid when the Biot number is small.
- Constant , and .
- Entropic heat neglected.
Discrete form for a BMS
A BMS samples at a fixed step . Holding constant over each step, (4) gives the exact recursion
which costs one multiply-add per sample. The same structure appears in Chowdhury and Lu's one-shot identification method[3], where (5) is rearranged to be linear in its parameters so that they can be fitted by least squares.
Limitations
- Large cells and fast pulses. Internal gradients make the surface cooler than the core; a two-node (core/surface) model is needed.[2]
- Entropic heat. Near-zero currents and some chemistries make the reversible term in Bernardi's balance significant.
- Changing cooling. depends on airflow; a fan or a neighbouring hot cell changes it.
References
- D. Bernardi, E. Pawlikowski and J. Newman, "A General Energy Balance for Battery Systems," Journal of the Electrochemical Society, vol. 132, no. 1, pp. 5–12, 1985.
- C. Forgez, D. V. Do, G. Friedrich, M. Morcrette and C. Delacourt, "Thermal modeling of a cylindrical LiFePO4/graphite lithium-ion battery," Journal of Power Sources, vol. 195, no. 9, pp. 2961–2968, 2010.
- M. A. Chowdhury and Q. Lu, "Equivalent-Circuit Thermal Model for Batteries with One-Shot Parameter Identification," arXiv:2503.12616, 2025. arxiv.org/abs/2503.12616